2.
Reception setup:
Fig. Q Fig. R
Loosen Paper Stop (shown in Figure Q) then turn and move so that the Paper Stop Arm
is aligned with center of page and width of page value matches the mark on the
horizontal guide, tighten Paper Stop. Loosen Drawer Screws (see Figure R) and pull out
reception drawer until sheet’s top edge aligns with LINE “A” yellow label and bar edge
(see graphics inside drawer). Lightly tighten screws.
3.
Accessing the Die with a HD-7700 machine.
Issue “A1” 09/03 P/N 900599 www.RHIN-O-TUFF.com
Fig. S
Turn both power switches off before removing a die or performing
maintenance. See Figure S. To change the die on a HD-7700, pull the
forward APES-14-77 Reception mounting pin and pivot the Reception away from the
HD-7700. This will allow access to the left HD-7700 die locking handle. Unlock both
handles, replace die, lock both handles, then swing the APES-14-77 Reception back in
place and replace forward mounting pin. If the die locking handles are loose enough,
swinging the APES-14-77 may not be necessary.
Page 13
