¾
Paper Pusher:
Fig. Y
See Figure Y. This guide was pre-setup. But if it requires re-setup, this is the
intended use: When the Ejector releases a sheet(s), the Paper Pusher should
slightly divert the sheet(s) toward the Reception Paper Guide face. This action
allows the Reception Paper Pivot to better stack paper. The Paper Pusher is
necessary on all jobs but it is most important for Portrait jobs.
4. Ejector Setup 5-1/2” and Smaller Paper.
Sheets that stand 6” tall may use either Ejector setups. Sheets shorter than 6”
must remove the Bracket Assembly to access the sheets within APES-14-77;
Fig. Z
Page 16
Issue “A1” 09/03 P/N 900599 www.RHIN-O-TUFF.com