¾
Push the APES-14-77 Ejector Base Plate Assembly lightly back against the front
of the HD-7700 punch.
¾
Notice the Rear Paper Guide on each side of the machine in Figure F1;
Fig F1
The Rear Paper Guide will fit exactly between both HD-7700 side plates and rest
against the front of the HD-7700 top front cover. Locate the APES-14-77 into this
position without bending the Rear Paper Guide forward.
¾
Install and tighten the two 3-winged mounting knobs provided into the last (rear)
mounting slots. See Figure F (page 8).
¾
Move the APES-14-77 Reception Assembly next to the HD punch. See Figure G.
Note that the Reception Pivot Block will align centered about the Ejector Top
Plate Reception Mounting Bar as shown. See Figure G1.
Fig. G Fig. G1
Move the APES-14-77 Reception next to the HD punch
¾
These alignments were made during manufacturing, but if the reception fails to
align with the Ejector Top Plate you will need to adjust the Reception Pivot Block
with two adjustment screws at the base of the Pivot Block Mount just under the
lid on the inside of the Reception. See Figure H (page 10).
Page 9
Issue “A1” 09/03 P/N 900599 www.RHIN-O-TUFF.com
