Pressing
buttons 4
and
5
increase or decrease respectively the mixer speed of the selection. The
values go from 1 to 5. The maximum speed is set programming the value 1. Pressing again
button 2
the
display shows:
selection name:
standard
Pressing
button 4
and
5
it is possible to modify the message shown in the display during the preparation
of the drink. If you select the value
standard
, the display will show:
drink number N
preparing
otherwise if you select one of the available selection names the display will show:
selection name
preparing
Press
button 1
to programme the following button.
Setting of a pre-selection
To associate a
pre-selection
to the current button, choose
PRESELECTION
pressing
buttons 4
and
5
.
Pressing again
button 2
the display shows:
presel. message
JUG
Pressing
buttons 4
and
5
the display shows all the other available pre-selections. Pressing in sequence
button 2
on the display will appear:
habil. Presel.
Button 1 YES
Press
buttons 2
and
3
to visualise the sequence of selection buttons, then chose YES or NO with
buttons 4
and
5
in order to set in function or to enable pre-selection. Pressing jug pre-selection before
buttons for which it has been enabled, the machine will repeat the settled drink for the times the
parameter has been programmed ENABLED, JUG NUMBER.
Programming CONTINUOUS DISTRIBUTION of a selection
Proceed as for programming a standard selection matching however very low values to product motors,
waters, mixers, etc….because such values, when different from zero, have the only aim of activating the
related actuator. Keeping pressed the button for continuous distribution gets stated the lasting of the
related output.
ATTENTION:
take care to carry correctly out the activation sequence for product, water, mixer.
Press
button 1
to go on programming the following buttons.
12.5.2 Modification of the operating temperature
The machine defines and regulates water temperature in the boiler. To modify the temperature
thresholds, in the programming mode, press
button 1
until the sub-menu
PROGRAMMING
TEMPERATURE
is displayed. Pressing
button 2
the display shows:
TEMPERATURE
Instant Boiler 85
Pressing
button 4
and
5
set the value. At the end of programming, press
button 1
to confirm the set
data.
12.5.3 Modifying other operation parameters (miscellaneous)
To modify parameters, in the programming mode, press
button 1
until the sub-menu
PROGRAMMING
MISCELLANEOUS
MAN1260007 V.1 – 18/12/2014
22
Summary of Contents for Horeca Large 380
Page 33: ......
