11.1.2 Temperature setting
To operate changes on settled temperature,
after loading water on the boiler,
insert the key on the
safety switch and wait for the message on the display:
rheavendors
HORECA LARGE 380
place
your jug
Push the
button
on the display board inside the machine.
1=PROGR 2=DATA
3=FREE 4= CLEAN
Press again button
1
until the display shows:
PROGRAMMING
- BUTTON 1 - - - - - - -
Press again button
1
until the display shows:
PROGRAMMING - - -
TEMPERATURE - - -
Pressing
button 2
the display shows:
TEMPERATURE
Boiler 10
Pressing
button 4
and
5
set the correct value (the suggested values are 85°C for Instant machines and
92°C for Espresso machines). Press
button 1
to confirm the data and then the
button
inside the
machine on the display board to exit from PROGRAMMING. Switch off and on the semi-automatic
vending machine using the safety switch. At the end of the operation the display will shows:
11.2 Second installation phase
The second phase of the installation of the machine contains the cleaning of the parts in contact with
foodstuff, the loading of the food products and the installation of some accessories.
11.2.1 Washing and disinfecting of components in contact with
foodstuff.
With the semi-automatic vending machine switched on, make sure that the display shows:
rheavendors
HORECA LARGE 380
Place
your jug
Press the button on the display board placed inside the machine. The display will show:
1=PROG 2=DATA
3=FREE 4= CLEAN
Carry out the cleanings of the mixing bowls pressing
button 4
; the display shows:
CLEANINGS
SEL 1-2-3- - - - - - -
Press
buttons 1
,
2
and
3
. With all these three buttons use about 3 litres of water altogether (the button 1
carries the cleaning of the group out; the other ones the cleaning of the existing mixing bowls). This will
remove any possible trace of dirt from the boiler. Press the internal button on the display board inside the
machine.
MAN1260007 V.1 – 18/12/2014
17
Summary of Contents for Horeca Large 380
Page 33: ......
