Rheavendors Group Cino XS Grande Pro VHO, Installation And Maintenance Manual

Page: 34 / 51

TEST VEND
DRIPTRAY
EMPTY 1=START
WATER OK?
4=START
TUNING MOTOR N
+00 %
code ID 101
00
code ID 104
00
code ID 106
00
address VIDTS
00
CLEANING
SEL. 1-2-3-4
CLEANING N
DATA AUDIT 0=TLMS
1=IRDA 2=OFF 0
TUNING GRINDER N
+00 %
BREWER DIAMETER
0=36 1=45 01
POSIT. STAND BY
0=CLOSE 1=OP. N
WATER FILTER
CNT [00] 0000
DEC. GROUP CAFE
CNT [00] 0000
DEC. COF. GROUNDS
CNT [00] 0000
Cino XS grande PRO VHO by
MAN2100154 rel. 00 dated 04.11.2013 page no. 34 of 51 pages
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
exclusive property of rheavendors group
09.01.q. tuning motors
09.01.r. id. machine
09.01.s. var. brewer
09.02. “data”
09.03. “free vend”
09.04. “clean”
09.05. “maintenance”
compared to setpoint values in 09.01.a.:
- the rotation time of each product motor can be varied (keys “ 4 ”
and “ 5 ”) by +/-30%; the variation concerns all activations of the
product motors for all selections;
- the activation time of the grinder motor can be calibrated by +/-
30% compared to setpoint values; when fixed, even this increase
or decrease is constant in each activation;
identification codes to detect EVA DTS data
- machine number;
- location number;
- machine configuration;
- address for connection with the DDCMP protocol;
- 0 = for audit via telemetry (option); 1 = to enable the IRDA
detection; 2 = to disable the detection;
to set the diameter of the coffee brewer installed in the machine;
it decides whether to keep the percolation chamber of the coffee
brewer inserted in the upper piston or not in the standby phase;
select the option “data” to display the data concerning the
dispensing cycles performed in sequence, like in 09.01.h.;
it dispenses selections on a free basis; the selections made in this
mode are counted separately (09.01.h.);
choose this option after having observed the instructions on the
display, i.e. after having made sure that the drip tray is empty:
and that the machine is connected hydraulically:
press “ 1 ”, “ 2 ”, “ 3 ” or “ 4 ” to dispense a pre-fixed water quantity to
wash the corresponding circuit (see 08.03.);
the display shows:
press keys “ 4 ” and “ 5 ” to programme the following variables and
set the thresholds, beyond which a caution message will appear on
the display of the machine at the end of the dispensing cycles set
up;
value, beyond which the machine signals that the inlet water filter
shall be replaced;
value, beyond which the machine signals that the variable coffee
brewer shall be serviced;
value, beyond which the machine signals that the grounds drawer
shall be emptied;