09.06. data support
the values of the variables composing the machine programming
(configuration) can be transferred to an external support, i.e. the
flash key; to transfer the machine parameters to the key:
- power off the machine;
- open the door;
- insert the flash key into the orange carter slot (see
05.15.);
- power on the machine with the service key (see 05.13.);
- the display shows:
- press
“
2
”
;
- and wait for the display to show:
- power off the machine and remove the flash key;
now, the flash key contains all the parameters typical of the
machine from which they have been fetched. If you wish to
programme another vending machine with these data, the previous
procedure can be repeated by pressing key
“
1
”
instead of
“
2
”
: the
information will be transferred from the flash key to the vending
machine; both procedures will not alter the data contained in the
supports from which they have been fetched;
1 from key to VMC
2 from VMC to key
END PROGRAMMING
wait ………
Cino XS grande PRO VHO
by
MAN2100154 rel. 00 dated 04.11.2013 page no. 35 of 51 pages
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: [email protected]
exclusive property of rheavendors group
