RGB Spectrum QuadView UHDx, User Manual

Page: 55 / 72

350-12245-01 – updated December, 2019 QuadView UHDx/UHDx KVM User Guide 43
C H A P T E R 4
C o m m a n d L i n e C o n t r o l
RG B
You may change the QuadView UHDx baud rate using either:

The Serial Baudrate control on the Advanced tab of the QuadView UHDx Web Controller.
See “The Advanced Tab” on page 34 .

One of the Set Baud Rate commands listed in Table 4-5 .
The serial command syntax is as follows:

Case: Commands are case-sensitive. Alphabetic characters must be in UPPERCASE.

Spaces: You can use spaces to separate the components of a command for improved
readability. (This option is used in the following command lists.) The QuadView UHDx
command parser ignores spaces; for example,
ATM 0A VDO_IPT W 3 2
and
ATM0AVDO_IPTW32
are both valid command strings.

Command header:
ATM

Length: The total length of the command and parameters, not including the header or spaces,
given in hexadecimal (
08 ... 25
).

Command:
XXX_XXX

Read/Write:
R/W

Parameter data: The length and meaning of the parameter data (if required) is dependent on
the command.
4.3.1 General Commands
Table 4-1 describes the general QuadView UHDx general commands. These commands provide
the same controls as those found on the General tab of the QuadView UHDx Web Controller
interface. See “The General Tab” on page 22 .
4.3 Command Syntax and Lists
No t e
You need not send a carriage return or press [ENTER] following the command when using a
serial connection.
Table 4-1 General Commands
Function Command Feedback Description
Report Input Name ATM 09 IPT_NAM R [1…6] ~INPUT[1...6]:
[input_name]
Reports the name of Input
[1...6].
Example:
Input 1 name = CAMERA
ATM 09 IPT_NAM R 1
~INPUT1: CAMERA