RG B
C H A P T E R 3
Op e r a t i o n
24
QuadView UHDx/UHDx KVM User Guide
350-12245-01 – updated December, 2019
3.8.2
Crop Input Settings
The
Crop Input
area of the
General
tab appears as shown in
.
Figure 3-7
General > Crop Input Settings
You can crop an input signal to highlight a region of interest. To do this:
1.
Check the
Enable
box for the input source you wish to crop.
2.
Enter the
X
,
Y
,
Width
, and
Height
values that define the region of interest by either:
Typing values directly.
Using the spin controls.
3.
Click
Set
.
To remove cropping from an input signal:
1.
Clear the
Enable
check box for that input source.
2.
Click
Set
.
Ti p
You may use the [UP ARROW] and [DN ARROW] keys to change the X/Y, width, and height
values in small increments. The increment size depends on the output resolution.
E x a m p le
To crop a 1920 × 1080 source to show only the bottom-right quadrant, use the followinge
values:
X = 960
Y = 540
Width = 960
Height = 540
