RFNet Wireless LAN Access Point AP-I002
Please follow the above instruction and type a correct IP address and then click “OK” button. After
inputting the correct login name & password, you can use Telnet to set the parameter of the AP-
I002. Both the default login name and password are RFNET (please note all the alphabets are
upper cases).
2. Command through Telnet
Using the commands through Telnet speeds up the time it takes to get response if you are familiar
with them. Once you type a correct command, the related information will appear on you screen in
no time. Currently there are about 10 commands for Telnet. They are as follow:
3) addmac
You can use this command when you want to add one legal MAC address, for example, to add in
00123456789a to the list, just type
addmac 00123456789a
. If you want to confirm the format of the
command, typing
addmac
without any successor will give you an example.
4) conf
You can set most of the parameters with this command. The format of this command is:
conf
name-of-parameter value
. For example, if you wish to change the previous active channel to
channel 6, simply type:
conf channela 6
, which will change the channel number of slot a to channel
6. To activate this change, you need to type in
enable wireless
. You can use the
show
command
to know more about all the parameters you can set, for there is an explanation for each parameter.
5) copy
This command is used for you to save the parameters in RAM into Flash. After setting up all the
parameters, just issue a command
copy ram rom
and as a result, the AP-I002 saves the
parameters you set.
6) delmac
This command is used to delete a particular legal MAC address. Refer to the example in
addmac
part above, you can delete the MAC you added just now by issuing command like
delmac
00123456789a.
7) enable
After setting the wireless parameters, you must issue this command to activate them. The
command is:
enable wireless.
8) history
User Manual
25
