RFNet Wireless LAN Access Point AP-I002
Chapter 3 Using Your AP-I002
3.1 Installation Requirements
While installing, AP-I002s must satisfy the following requirements:
•
Connect the unit to a grounding type AC wall outlet (100-240 VAC) using the standard power
cord as supplied with the unit.
•
Must allow easy disconnection the access point unit from the AC wall-outlet.
•
Do not cover the unit, or block the airflow to the unit with any other objects.
•
Must keep the unit away from excessive heat and humidity and keep the unit free from
vibration and dust.
•
Installation must at all times conform to local regulations.
Should you connect AP-I002 to an outdoor antenna system or external accessory, please consult
the documentation that came with the outdoor antenna kit for additional regulatory information,
safety instructions and installation requirements.
3.2 Best Place for the AP-I002
Try to position - AP-I002s in an open environment with as few obstructions as possible for optimal
performance. To ensure the best link quality:
•
Place the AP-I002s as high and as centrally as possible (relative to the mobile wireless stations
in the vicinity).
•
Do not conceal the integrated antennae of the AP-I002.
•
Do not place AP-I002 too near to metal wall.
3.3 Connecting Stations to Your AP-I002
A unique Wireless Network Name or Service Set Identification (SSID) identifies IEEE 802.11b
Wireless Networks. All Access Point that belong the same Wireless Network Infrastructure will
share the same SSID.
To establish communication between your station and the Access Point, you can configure your
PCM-01 PC Card to:
•
Connect to any wireless LAN (SSID) or
•
Connect to a specific wireless LAN (SSID)
3.3.1 To Connect to Any SSID
This is recommended if you intend to connect your PC to various networking environments. By
using this setting, your PC that equipped with the PCM-01 WLAN PC Card will connect
automatically to any Access Point that provides the best level of communications.
•
Open your Wireless LAN Configuration Utility and click on the ‘Configuration’ tab.
User Manual
13
