RFNet Wireless LAN Access Point AP-I002
To Better Utilize the Bandwidth
Depending on how much bandwidth is available, you are advised to fragment a large packet before
transmitting to achieve best result. That is the fragmentation threshold of the wireless interface.
The valid range is from 0 to 2346. We recommend to remain this value as default for better
performance.
To Set Transmit Rate
Normally we set it to automatic mode, yet you can modify the setting when you feel it is necessary.
To Use WEP Function
You can choose to disable the WEP function or turn it on. To turn on the WEP function, you must
specify one of the WEP keys, which are WEP key 1, 2, 3, 4. Each WEP key must consist of 10
hexadecimal characters for 64-bit encryption and 26 hexadecimal characters for 128-bit encryption.
When you turn on this WEP key, please keep in mind that you must specify the same WEP key in
the client side.
In the Ethernet parameter category, you can set the following parameter:
To Decide IP Mode
You can decide this AP-I002 to work either in the DHCP or static IP mode. If you choose DHCP,
there is no need for you to specify the detailed IP address of AP or router etc. If you choose static
mode, normally the setup page will show the current IP address in the static IP field at your
convenience. So if you want to fix the current IP address, just check the
static IP
option.
Static IP, Subnet Mask, Gateway, DNS
In static IP mode, you must specify the correct values of these parameters for you to access the
AP-I002.
Nonunicast Threshold
This is to specify the threshold of multicast or broadcast the AP-I002 is handling. When the
nonunicast packets come through faster than this threshold, the AP-I002 will discard some of them.
Protocol Filter
Here you can select the protocols you want to filter out. To select multiple protocols, just hold down
ctrl while click the mouse.
To Enable MAC Address Control List
This is to enable or disable the Mac address control function. Just tick it when you want to enable
the MAC address control. Remember to add the legal MAC address list in the below box. To add a
legal MAC to the list, just type in. For example if you want to add on 009012345678, then just type
in 009012345678.
After the parameter is set, you either click the Apply button to activate it or click Save button to
save it into flash and enable it. Please note that if you want to change the IP setting, you must save
it and power up the AP again.
To Change Password
User Manual
22
