REYNAERS 062.8620, Installer Manual

Page: 17 / 86

English
Nederlands
Fr
ançais
Deut
sch
17
4. SOLVING PROBLEMS
Problem Possible cause(s) Solution
Motors do
not respond Cables not properly
connected Check the cables
Terminating resistor not
connected Place the terminating resistor
on the last motor in the series
The red LED 602 is flashing.
The EC is not configured. Run through the set-up
procedure.
The yellow LED 602 is
flashing.
The EC is in set-up mode. Run through the set-up
procedure to the end.
The green LED 603 lights up.
The EC is in service mode. Press the SET-UP button so
that the green LED 603 goes
out.
5. TECHNICAL SPECIFICATIONS
• Power input: 24 V DC, 0.75A
• Physical Dimensions electrical cabinet: 9 units, 161 mm
• Environmental Operating temperature: 0° to 40° C (32º to 104º F)
• Operating humidity: 90% maximum relative humidity, noncondensing
• Regulatory compliance designed to conform to the following standards: CE
EN301489-17
• Interface specifications ethernet: 10or100BASE-Tx, RJ-45
• Wireless interface: 2.4GHz, 5GHz, 802.11 abgn with WPA2 security, BT BLE
4.1
• USB interface: USB2.0 hub
• RBus output
• Button input with LED feedback
For more information visit:
http://setup-ec.reynaers.com/