Revv Owner’s Manual - 39
Note: Any change made on the front panel of the amp will result in a bank
LED blinking which means that the current bank setting is different from
that of the amps new configuration. To save the new setting press the
bank button on the footswitch (blinking LED), or, to reset the configura-
tion & not keep the change, simply press another bank button & the
change will NOT be saved.
Memory Reset
The footswitch memory can be cleared when it is needed. Each of the 4
banks will be returned to factory defaults. In order to reset the memory &
return the unit to factory defaults, begin with the amplifiers power off &
the footswitch plugged into the footswitch jack on the amplifier. Next,
press & hold buttons 1 & 2 down & turn the power switch to the ON posi-
tion on the amplifier.
As soon as the footswitch powers up it will return all memory locations to
factory defaults as long as buttons one & two were held down properly at
power up.
Mute & the footswitch
The amp can be muted via the foot pedal by pressing & holding button
six for 2 seconds in any mode. Once the amp is muted the LED will flash
until mute is turned off. Mute can be turned off by pressing button four
again & quickly releasing it.
7.4
7.5
