Revv Owner’s Manual - 30
4)
You can do this with a computer for automatic changes during songs,
a MIDI floor control unit instead of our footswitch, a loop switcher with
midi to control pedals as part of the “presets,” a multi-effects unit with
MIDI control, & more.
5)
You can do this with just our footswitch, or not at all, if you choose.
External equipment just becomes more beneficial when integrating your
Revv with additional pieces of a rig such as effects units.
OMNI Mode
OMNI mode off will allow the amplifier to be controlled via a designated
channel (1-16), & OMNI mode on will allow the amplifier to respond to
commands on any channel.
If other equipment is being used in a MIDI system, it is desirable to set
each piece of equipment to separate channels. However when the am-
plifier is the only piece of gear being controlled via MIDI, then setting it to
a specific channel is not really required & setting the OMNI mode on
becomes preferable.
In order to toggle OMNI mode on or off:
1)
Make sure the power switch is in the off position.
2)
Press & hold “masters” toggle switch.
3)
With the “masters” toggle switch being held, turn on the power switch.
4)
Release the masters toggle switch once the masters LED begins to
flash. Once the “masters” LED has stopped flashing, it has accepted the
command to adjust OMNI mode. The amplifier will adjust OMNI mode &
then reset itself by completing its startup sequence. Once the start-up
sequence is done (2 seconds) & the CH1 CLEAN LED is illuminated, you
are ready to go.
Note: The masters LED will flash 3 times when it turns OMNI mode on, &
4 times when it turns OMNI mode off.
6.1
