Revv Owner’s Manual - 37
Control Mode
The foot pedal will always power up in control mode. This mode works
similarly to most other foot pedals - it simply controls the functions of the
amp. Here is how the buttons respond in control mode:
Button One
– This button has 3 functions, it switches to channel one
when the amp is not in channel one, changes channel one to either the
clean amp mode or crunch amp mode when the amp is already in chan-
nel one, & switches between foot pedal modes when held for 2 seconds
(control & preset).
Button Two
– This button has 2 functions in control mode, it will switch to
channel two when the amp is not in channel two, & it will change the
aggression level but only when the amp is already ion channel two. The
LED for channel two will change according to aggression level.
Button Three
– This button toggles the FX loop In/Out. If the FX Loop is
not turned on however, the FX Loop will not be changed, the LED will flash
a few times to signal this.
Button Four
– This button has two functions in control mode. It is used to
switch between the 2 master volume controls as well as turn mute on &
off. When the button is pressed & released, it will change the master
volume controls. When it is held for 2 seconds it will mute the amplifier &
the LED will flash.
Note: Bright & Fat functions cannot be changed via the footswitch as
they are considered to be an extension of the EQ. They can be saved to
a bank when in Preset mode however.
7.2
