Revv Owner’s Manual - 14
This can be controlled by pushing down on the labeled front panel mo-
mentary switch. The Red LED will flash when the amplifier is in mute.
Manual Mute can also be turned on by holding down button #4 on the
footswitch for 2 seconds, as well as with MIDI control.
Note: It is not possible to program mute into a footswitch preset bank.
Button #4 on the footswitch will control mute in any footswitch mode.
C - Serial FX Loop Switch
The FX Loop toggle switch turns the serial FX loop on & off, as well as in &
out of the signal path. On & off is selected by pushing the toggle switch
up & releasing it quickly, in & out is selected by pushing the toggle switch
up & holding it until the LED flashes. The on & off selection will set the
amp to use the FX loop & activate the FX loop footswitch button #3 for
use. When the FX loop is not being used it can be turned off & the
footswitch will react to this condition by flashing the LED when stepped
on.
The in & out control of the FX loop simply does what the footswitch
would do when stepped on, it takes effects in & out of the signal path.
This feature was added to be able to set the in or out condition of the FX
loop to a preset bank on the footswitch when the footswitch is in preset
mode, or to control the in or out function when the footswitch is not
plugged in to the amp.
Note: This amplifier is set by default to startup with the FX Loop turned
off. If you want to bypass the feature & want the FX loop to turn on auto-
matically at startup , simply power off the amplifier, press the FX Loop
toggle switch up & hold it, then turn the main power switch to the on
position. The FX Loop LED will flash & immediately turn the loop on. Now
whenever you turn the amplifier on, the FX loop will also be on & ready to
be put in & out of the signal path as you wish.
