8
Charge,
discharge, cycle
or monitor a
pack
1. Apply power and select power source (see above).
2. Connect pack.
3. Press
INC
or
DEC
to select desired User Preset, then press
ENTER
.
4. For each question, press
INC
or
DEC
to select correct answer, then press
ENTER
.
5.
CHECKING PACK
indicates Dual PowerLab 8x2 is attempting to detect
attached pack.
6.
Screen displays preset’s chemistry. If this matches pack’s chemistry, press
ENTER
to start. (If they don’t match, just wait for the next prompt, then press
ENTER
to return to the User Preset menu.)
7. During the operation:
Press
INC
or
DEC
to view data.
Press
ENTER
to change charge current.
Press and hold
ENTER
to stop the operation.
8.
“Beep beep beep” indicates the operation is complete. Display shows
elapsed time. Press
INC
/
DEC
to review data. Operation is complete, but
“session” remains open so you can review collected data. Press and hold
ENTER
to terminate session (this erases session data).
9. Disconnect pack.
10. Press
ENTER
to return to User Preset menu.
Charge packs in
parallel
To ensure safety, only use REVOLECTRIX Safe Parallel Adapters and stackable
safety banana plugs or the MPA when charging/discharging/cycling packs in
parallel. Connect up to 16 batteries of same chemistry, cell count and capacity in
parallel by stacking banana plugs. Charge as above, but enter number of packs
at
Parallel Packs?
question (e.g., 2P, 3P, 4P). Dual PowerLab 8x2 multiplies
preset’s current setting by the number of “P” selected.
*Assumes
Choose Power Source at Startup
is enabled in the CCS.
Summary of Contents for Dual PowerLab 8x2
Page 17: ...17 See also Charge packs in parallel ...
Page 19: ...19 ...
