28
5. During charging:
Press INC or DEC on the Primary unit to view charging data. Data will be
displayed on each Dual PowerLab 8x2 for the pack connected to that unit.
Press
ENTER
on the Primary unit to override the charge and discharge current
(for all units).
To stop charging on all units:
On the Primary unit, press and hold
ENTER
. You’ll see
CHARGER
STOPPED
.
Press
ENTER
to return to the User Preset menu.
6.
When charging is complete, each unit will “beep beep beep” several times and the
display will show
ELAPSED [time] / [chemistry] DONE
. On the Primary unit, press
INC
or
DEC
to review charging data screens. Data will be displayed on each Dual
PowerLab 8x2 for the pack connected to that unit.
7. After all units have completed charging, on the Primary unit press and hold
ENTER
.
Screen displays
CHARGER STOPPED
.
8. On the Primary unit, press
ENTER
or
BACK
to return to the User Preset menu.
9. Disconnect the packs from all units.
Tip:
You can also monitor charging data, and view data in graphs, in the
Charge Control Software. In the
Cells
,
Int. Res.
and
Supply
tabs, use the
drop-down lists to display data from the Expansion Channel.
Note:
The operation is now complete, but the “session” remains open so you
can
review collected data. Once you press and hold
ENTER
, data collected
during the operation will be discarded. If you disconnect the pack before
ending the session, Dual PowerLab 8x2
will display a “PackRemoved” error.
This is a non-critical error, and you can ignore it in this situation.
Note:
NiMH, NiCd and Lead Acid user presets may switch to trickle charge
(depending on how the preset is configured) when charging is complete.
Summary of Contents for Dual PowerLab 8x2
Page 17: ...17 See also Charge packs in parallel ...
Page 19: ...19 ...
