Revere 45-AE4V, Service Manual

Page: 138 / 234

Oct 21/16
8 - 26
9101
26. After making sure all vacuum bag corners are contained within the valise, shut the valise by
mating all velcro strips together.
27. Place completed inspection sticker on valise. (See Section 2 - Description Fig. 3)
Packing into Container
19. Locate the bottom container shell and place it on the floor of the working area.
20. Place vacuum packed raft into container with cylinder inflation valve oriented toward the hole in
the side of the container. (See Fig. 15B)
21. Place painterline sachet assembly lengthwise on top of the vacuum sealed raft with the cord
facing the inflation valve. Tape down with black gaffers tape. (See Fig. 15B)
22. Measure 1ft. from the exposed portion of the painterline cord closest to the loop patch on the
vacuum bag. Using a screwdriver or another similar object, create a hole in the painterline.
CAREFULLY slip cord over the inflation valve pull cable loop and drag it down until it has cleared
the loop. Bring the end of the cord back through the loop and tie using a bowline knot.
(See Fig. 16)
23. Tie the end of the same painterline cord to the exterior loop patch on the vacuum bag. Leave
1in.-2in. worth of additional line and tape down with white adhesive tape. Tape should extend
1in. past the extra length of material. (See Fig. 12)
24. Place the foam plug (IPL Fig. 4, Item 7) into the cut-out hole in the bottom container shell.
Orient so the hole in the foam plug is facing outward and towards the bottom. Pass the end of
the other painterline cord through the hole in the foam plug. (See Fig. 15B)
Note: Before operating container strap fastening tools, read the operating
instructions in the tool operation and parts list.
Warning: Operator should position themselves to one side of the strap when tensioning.
Maintain proper footing and balance when operation equipment. Do not
operate equipment when you are in an awkward position.
Caution: Use short handle strokes during tensioning. BE CAREFUL – Too much tension
will break the straps.
25. After the raft and vacuum bag are enclosed in the bottom container shell, place the top container
shell over the bottom shell being sure to align the cutout hole with the grooves in the foam plug.