Resson Technologies RD-11M, Operation Manual

Page: 68 / 94

On Off
RD-11M
R
esson
Technologies
ent
R
I
O
Z 0.000
0.00
0.000
0
- 64 -
Move the X axis until display
= 0.000, then the tool is
positioned on the ARC curve
The display will shift left
to signify it is not normal
co-ordinate display.
If the axis is positioned outside the curvature, will display " " ( Z R RD-11M Z OU LI Z OUT LIMIT )
During the XZ or YZ plane R machining, it is necessary to carefully position the Z axis to obtain a precise
Z position. As, there is no Z axis in the two axis RD-11M, and, in order that the operator can easily guide and
position the Z axis during the ARC machining, the RD-11M uses the unused axis display to display the
Z dial
turn number Z dial reading. and
At the beginning of the ARC machining, the RD-11M will assume the Z axis dial at zero position with the tool
positioned at the starting point of the ARC. Press the and once to simulate Z axis move up or
down for one step - the corresponding Z dail turn number and Z dial reading will display on the unused
axis. The operator must move the Z axis according the dial reading display on this axis, then the correct
Z axis height is reached..
Z axis simulated height
Z dial turn number
Z dial reading
move the Z axis
according to the dial
settings displayed
on Y axis
Display data in plane machining mode XZ R
X = 0.000
X = 0.000
Two axis machining mode RD-11M - ARC
R
esson
Technologies