Resson Technologies RD-11M, Operation Manual

Page: 41 / 94

- 37 -
- ( Centre CENTRE )
DIA - ( ) Diameter
- ( ) No. of Holes NO. HOLE
- ( ) Start Angle ST. ANG
- ( ) End Angle ENd. ANG
Angular direction :
Positive ( + ) - Clockwise
Negative ( - ) - Anti-clockwise
Y(+)
X(+)
Function :
RD-11M provides a PCD function to for drilling holes around a Pitch Circle Diameter.
The operator simply enters the following machining parameters in accordance with
the step by step guides shown on the RD-11M's message display,. The RD-11M will then
calculate all the pitch hole position coordinates and temporarily preset the hole
position coordinates to zero ( 0.000 ). The operator then moves the machine until
the display axes = 0.000 and the pitch hole position is reached.
After the above machining parameters
are entered into RD-11M, it presets all
the pitch hole positions to 0.000
Operator can press or to select
the pitch hole, and then move the machine
to display = 0.000 - the pitch hole position is then reached
Centre Coordinate ( CENTRE ) ......... X= 0.000, Y=0.000
Diameter ( DIA ) ............................... 80.000mm
No. of Holes ( NO. HOLE ) ................ 5 holes
( Start Angle ( ST. ANG ) ..................... 30 degree
) clockwise
End Angle ( ENd. ANG ).................... 300 degree
( ) clockwise
= 30 degree
= 300 degree
X = 0.000
Y = 0.000
Centre
Diameter
Start Angle
End Angle
= 80.000
step 1 : Set up the work piece datum ( work piece zero )
to enter the function
PCD
set up work piece datum
enter the coordinate CENTRE
to enter the
function PCD
R
esson
Technologies
On Off
RD-11M
R
esson
Technologies
ent
R
I
O On Off
RD-11M
R
esson
Technologies
ent
R
I
O
0.000
0.000
CRNTRE