Hard-Wired Solar Siren Test
Press
The internal relay driving the hardwired siren will be
switched ON for a period of approximately 5 seconds.
Zone LED 2 will be illuminated during the test.
Solar Siren Test
Press
The Control Panel alarm and the External Solar Siren
will be operated for a period of approximately
5 seconds with the external Solar Siren switching ON
and OFF a few seconds after the Control Panel.
Zone LED 3 will be illuminated during the test.
Control Panel LED Test
Press
Zone LED 4 will illuminate.
Use and buttons to scroll through and
illuminate each LED in turn.
Press to exit LED
Voice Dialler Test
Press
Zone LED 6 will illuminate.
The voice dialler will call each activate number in the
dialling sequence in turn. When a call is answered the
pre-recorded alarm message will be replayed. If the
call is unanswered or an acknowledgement signal is not
received from the number called, (i.e. by pressing the
button on the telephone keypad) the next number in the
sequence will be called.
Press to exit voice dialer test.
Factory Defaults
Reset Factory Default Conditions
1.
Press
to place the system in Test Mode.
2.
Undo the Control Panel cover fixing screws and
open the cover.
3.
Switch OFF the mains supply to the plug-in PSU
Adaptor.
4.
Remove either back-up battery and disconnect the
battery leads.
5.
Set jumper link P1 to the ON position.
6.
Reconnect the battery leads and replace the back-
up battery in position.
7.
The Control Panel will now set itself with all factory
default settings. This takes approx. 10 seconds.
8.
Reconnect and switch On the supply to the PSU
adaptor.
9.
Reset jumper link P1 into the OFF position.
10. Close the Control Panel cover and refit the fixing
screws.
18
6
ESC
User Access Code
1 2 3 4
Alarm Duration
3 minutes
Hardwired Siren
Equal to Alarm Duration
Zone Operating Mode
Zones 1-6: Intruder
Part-Arm
Zones 1: Disabled
Zones 2,3,4,5,6: Active
Instant/Delay
Zone 1: Delay
Zones 2-6: Instant
Entry/Exit Delay
30s
Entry/Exit Warning Tone
On
Zone Lockout
On
Jamming Detection
Off
Phone Numbers
Not programmed
Message Play Time
70s
Alarm Message
Not programmed
Call Routing
All numbers disabled
Call Attempts
3
Dial Method
Tone/DTMF
?
?
?
?
,
,
User Access Code
4
ESC
2
3
Summary of Contents for SA3 E PLUS
Page 31: ...Notes 31...
