Press the key corresponding to the required delay
setting required, the corresponding zone LED will
illuminate as the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
Alarm Duration
Default setting: 3 minutes
Press
The zone LED corresponding to the current setting
will illuminate.
0 no alarm
1 1 minute
2 2 minutes
3 3 minutes
4 5 minutes
5 10 minutes
Press the key corresponding to the required alarm
period, the corresponding zone LED will illuminate as
the setting is changed.
Note: When set to ‘No alarm’ the Siren will sound for
approx. 10 seconds if an alarm condition is initiated.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
Note: Following initiation of a Full Alarm condition
the External Siren will continue to sound until either
the system is Disarmed; or the Control Panel Alarm
Duration Time expires; or if activated until the 3
minute alarm time limit of the external Siren expires;
whichever occurs first.
Part-Arm
Default setting: Zone 1
Disabled
Zones 2-6
Active
Press
The zone LEDs corresponding to the zones currently
active during Part-Arm mode will be illuminated. LEDs
for zones disabled during PART-ARM will be OFF.
LED ON Zone enabled in Part-Arm
LED OFF Zone disabled in Part-Arm
To change the setting of a zone press the button
corresponding to the zone number. The zone will toggle
between the two modes each time the button is pressed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
Zone Lockout
This feature, if enabled, prevents a single zone from
triggering an alarm condition more than three times
before the system is disarmed. However, if disabled
there is no limit on the number of times a zone can
trigger an alarm condition.
Default setting: ON
Press
The zone 1 LED will illuminate to indicate the current
Zone Lockout status.
LED ON Zone Lockout enabled
LED OFF Zone Lockout disabled
Press to change the setting to the opposite
state.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
20
6
7
5
ESC
ESC
ESC
1
ESC
Summary of Contents for SA3 E PLUS
Page 31: ...Notes 31...
