Replay Alarm Message
The recorded alarm message may be replayed and
listened to using the telephone handset of a phone
connected to another extension socket on the same
phone line.
Press
The zone 1 LED will illuminate.
Pick up the telephone handset and press to stop
the dialing tone.
Press to start replaying the recorded alarm
message.
Zone LED 1 will flash while the alarm message is
being replayed. At the end of the message the Control
Panel will beep twice and return to programming
mode. Alternatively press to stop replaying the
message before the end and return to programming
mode.
Call Routing
This controls which telephone numbers are enabled in
the dialing sequence and are dialed when the voice
dialler is activated.
Default setting: all numbers inactive
Press
Zone LEDs 1-4 will be illuminated to indicate the
active status of telephone numbers 1-4 in the routing
sequence. LEDs for telephone numbers disabled will
be OFF.
LED ON Telephone number enabled
LED OFF Telephone number disabled
To change the active status of a phone number press
the button corresponding to the phone number. The
LED will toggle between states each time the button
is pressed.
Press to save the new number and return to
programming mode.
Press to return to programming mode without
saving.
Call Attempts
This is the total time for which the alarm messages will
be played & repeated when a call made by the voice
dialer is answered.
Default setting: 3
Press
The zone LED corresponding to the current setting will
illuminate.
Zone 1 LED 1 attempt
Zone 2 LED 2 attempts
Zone 3 LED 3 attempts
Zone 4 LED 4 attempts
Zone 5 LED 5 attempts
Press the key corresponding to the required number
of dialing attempts, the corresponding zone LED will
illuminate as the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
Dial Method
This enables the telephone dialler to be set for the
type of exchange it is connected to.
Default setting: Tone/DTMF
Press
The zone LED corresponding to the current setting will
illuminate.
1 Tone/DTMF
2 Pulse
Press the key corresponding to the required dial
method, the corresponding zone LED will illuminate
as the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
23
3
2
5
2
6
2
4
2
ESC
ESC
ESC
ESC
Summary of Contents for SA3 E PLUS
Page 31: ...Notes 31...
