RAMP
® System Operation
Operator’s Manual, RAMP
®
Reader
21
Figure 2-3: Sample Results Printout Example
When all results have completed printing, the report indicates completion by printing the message:
END OF DATA at the bottom of the printout. The following message is then displayed:
NOTE:
If the printer is not properly connected or if the printer is not turned on, an error
message is displayed and the screen automatically returns to the OPTIONS Menu. Check
to ensure the printer is turned on and properly connected. Repeat the above steps.
After output is completed, if User Lock-out is disabled (Section 2.4.2), the screen displays the
following message:
To remove the type of results output from the memory, i.e. sample/ IQC /LQC, press [Enter] to select
Yes.
NOTE
: Pressing [Enter] erases all stored results from the specified memory. The operator
is asked to confirm this request.
If the [Enter] is pressed for the YES prompt, all results stored in the specified memory are erased and
a message specific to the database erased is displayed along with a double beep, as seen below for
SAMPLE MEMORY:
After displaying this message for two seconds, the screen returns to the Options Menu.
If the results are not to be erased from memory, press [▼] to move the cursor to the NO option.
Press either [Enter] or [Options] to return to the Options Menu. The results in memory will not be
erased.
SAMPLE MEMORY HAS
BEEN CLEARED
CLEAR MEMORY? >YES
NO
OUTPUT COMPLETED
RAMP Reader S/N XXXXXXX
Version X.XX
ID: Patient
USER: USER1
RESULT: TnI 0.40 ng/mL
DATE: 25 Jun 2015
TIME: 19:19
LOT: M0xxxx
EXP. 30 Jun 2016
END OF DATA
