5
Installation Procedure
Page 13
Resonance Technology, Inc.
CinemaVision System Installation / Operation Manual: RTC-CV Rev 19
5.3.
Magnet Room Component Interconnection
5.3.1.
Remove both upper and lower cable covers from the transducer.
5.3.2.
Unravel all the fiber optic cables from the plastic coil. Select the red (#1), green (#2), blue
(#3), black (#4), and brown (#5) connectors. Put the unused fibers back into the plastic coil. Remove
the plastic dust caps from the five selected fiber optic connectors. Keep the dust caps for future use
whenever cables might be removed for service.
5.3.3.
Remove the dust caps on all the fiber optic connectors on the transducer. Matching the fiber
optic connector colors with the labels on the transducer, align the ridge on the cable connector with the
notch of the transducer’s connector. Insert the fiber optic cable connector until fully seated, then
gently turn the ring clockwise until it stops (approximately one quarter turn). Perform the same
procedure on the remaining fiber optic cables.
5.3.4.
Secure the fiber optic bundle strain relief to the transducer housing. Make sure all of the
individual fiber optic cables have a smooth bend radius. The fiber optics can be damaged if bent too
tightly. Fold the protective tape over the fiber optic cables.
