137
7.2
Overview of status lines
A machine failure causes an error message to be displayed on the touch screen status line.
Table 12 lists possible messages, their causes and the solutions.
Table 12 Overview of status lines
No: Message
Cause
Solution
01 EMERGENCY STOP
The emergency switch has been
pressed.
Start the machine according to
the procedure described in
paragraph 5.2.5.
02
In Night Position
The machine is switched into
night position.
This is normal. See paragraph
4.3.1.1 for turning off the night-
time status.
03 Form tool not in position
*1
The form tool is not properly
mounted on the lifting system.
Push bottom die in position
04
Servo system is resetting
Servo cross cutting is moving to
zero position.
Every time with new startup
05 Servo system failure
Servo system in failure
Try to reset the servo system
06 Heater burnout Heating plate
The heating element in the
forming die top part is broken.
Call in the technical department.
07 Heater burnout Seal plate
The heating element in the seal
plate is broken.
08 Temperature outside limit
The sealing or forming unit has
exceeded the temperature
sensor’s range.
09 Temperature much too high
The temperature of the sealing or
forming units is too high.
11 No air pressure
The compressed air system is not
under pressure.
Check that the supply hose is
properly connected. If not, call in
the technical department.
12 No water pressure
The cooling water system is not
under pressure.
14 No central vacuum present
The machine has no vacuum.
Call in the technical department
15 Gas pressure too low
The gas pressure for injecting gas
into the packs has failed.
18 No oil in lubrication system
The chain lubrication system has
run out of oil.
20 Transport Inverter Error
The motor inverter is showing a
failure.
21 Small Inverter in Error
The motor inverter is showing a
failure.
23 Thermal overload motors
One of the motors has over-
heated.
25 Forming die not connected
Top die is not (properly)
connected to the electrical circuit.
26 Vacuum die not connected
27 Lifting systems not down
One of the lifting systems is failing
to reach the lowest position.
28
Form die doesn’t close
The bottom die is not coming to its
upper position.
29
Seal die doesn’t close
31 Out of Lower film
Bottom unwind is running out of
film.
Place new roll
32 Out of Top film
Top unwind is running out of film.
Place new roll
Attach the film again to rewind
33 Broken film trim
Film trim is broken (only rewind)
