18 0022771-01_BEDWHPV.1 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Using the Vision 1000 control panel
- Press and hold the
key (approx. 5 seconds) until
d.
(with flashing dot) appears on the display.
- The key is illuminated at the same time.
- After 5 seconds, the display switches to
d.
together with the running time of the
disinfection process.
If the
key flashes quickly, the disinfectant tank must be topped up (please refer to “Servicing”
on page 20).
- Automatic disinfection is started.
- The display shows the remaining disinfection time in minutes.
- Press the
key again to stop automatic disinfection
at any time.
- Once the disinfection process is complete, open the bathtub drain and let the
disinfection solution drain out.
- The remaining water is blown off automatically once the bathtub has fully emptied.
- The fan is automatically switched off after the end of the blow-out time.
- After approx. 5 minutes, dry the air nozzles and bathtub with a soft,
non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
Fresh water rinsing
(special accessory)
Fresh water rinsing starts automatically a few minutes after the whirlpool is completely drained and
cannot be cancelled. The jet system is rinsed first, followed by the air system. After this, the remaining
water is blown out of the air pipes automatically (only for Vision 500 and Vision 1000).
Dry the air nozzles and bathtub with a soft, non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
You can also start fresh water rinsing manually:
Using the Vision 500 control panel
- Press the
key when the bathtub is empty.
- Fresh water rinsing is started. The
key is illuminated until the end of the rinsing programme.
- Press the
key again to interrupt fresh water rinsing at any time.
- The fresh water rinsing ends when the rinsing time has elapsed.
- The remaining water is blown off automatically once the bathtub has fully emptied.
- The fan is automatically switched off after the end of the blow-out time.
Dry the air nozzles and bathtub with a soft, non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
Disinfection
Summary of Contents for Vision 1000
Page 27: ......