16 0022771-01_BEDWHPV.1 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
07 AFTER USE
08 DISINFECTION
First steps
-
Turn off all the whirlpool functions.
-
Open the bathtub drain and drain the water out completely.
-
Rinse out the whirlpool with hot water.
Automatic fresh water rinsing and blow-out
Irrespective of how the bathtub has been used - whether for a shower a bath or the whirlpool, the
fresh water rinsing programme (a special accessory for Vision 500, 700 and 1000) and blow-out (Vision
500 and 1000 only) is started automatically. The automatic fresh water rinsing and blow-out cannot be
interrupted.
- The
key flashes during automatic blow-out for the Vision 500 and Vision 1000
control panels.
- In addition,
2...1
is shown on the Vision 1000 control panel display during blow-out.
- The key is illuminated on all three control panels (Vision 500, 700 and 1000) during the fresh water
rinse programme.
If the fresh water rinsing system is present, the jet massage is rinsed first, followed by the air massage.
The remaining water is not automatically blown out of the air piping until this process is complete. If
automatic disinfection (special accessory) was selected while the bathtub was still full, no fresh water
rinsing takes place. Otherwise the disinfectant would be rinsed out.
Afterwards
Dry the air nozzles and bathtub using a soft, non-abrasive
and lint-free cloth. Leave the bathtub drain open.
Disinfectants cause skin irritation!
Ensure that you observe the safety instructions on the label of the disinfectant!
Keep disinfectants out of reach of children!
You must not bathe in the whirlpool whilst it is being disinfected!
Depending on the frequency of use, you should disinfect the whirlpool roughly
every 4 weeks. Only use Repabad disinfectant (art. no. 0002511). If other bath
agents are used, you run the risk of damaging the whirlpool.
Usage / Disinfection
Summary of Contents for Vision 1000
Page 27: ......