14 0022771-01_BEDWHPV.1 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Automatic filling
(Vision 1000 only)
If the bathtub is empty, start automatic filling by pressing the
key.
- Keep the
key pressed for at least 2 seconds. Automatic filling starts and the
key is illuminated.
- Press the
key again to stop automatic filling.
During filling, the following appears in the display:
Automatic filling running
Level control reached
Filling switches off, display switches to show temperature
After automatic filling switches off, you can continue to fill the bathtub by pressing and holding the
key. This runs for as long as the
key remains pressed.
Supplementary heating (a special accessory)
The supplementary heating (optional), if installed, is automatically switched on or off with the jet sys-
tem. The supplementary heating is not appropriate for heating cold water (e.g. from 20°C to 38°C).
The supplementary heating keeps the bath water at the target temperature set (setting range 10-
42°C). The latest set target temperature also remains set after disconnection from the electrical power
supply.
Screen display
38
The current water temperature
(with a full bathtub) is shown as standard. 38°C in this case.
...
There is not enough water in the whirlpool to use a function such as the jet
massage. Fill the whirlpool.
...
There is not enough water in the whirlpool to use a function such as fresh wa-
ter rinsing. Draining off water.
2...1
Display during automatic blow-out
--
Unavailable function selected (e.g. whirlpool lighting or supplementary heat-
ing) or keylock active
5 P
Fresh water rinsing manually activated.
After emptying the bathtub, automatic blow-out and automatic fresh water rinsing (a special ac-
cessory) is activated. This programme cannot be interrupted.
2...1.
is shown on the display (with a
flashing dot). Please also refer to pages 16 and 18, fresh water rinsing.
Operation
Summary of Contents for Vision 1000
Page 27: ......