Users Manual
7
AUX #1
1 2
O
N
Address Number Verification
Next verify that the Aux modules are properly identified. The settings were set at the factory, but it’s always a good idea to check them. This is
accomplished with the DIP switches located on the rear of each Aux module. Set the switches in accordance with the illustrations shown below.
Normally the Master module (ID 0 in RHAON II) is assembled at the bottom of an array and the other modules will be Aux IDs 1, 2 & 3 in ascending
order. However, the modules can be put in any order. For example, the Master may be installed on top to allow for a cable drop near the top of the
array. The DIP switch ID settings on the Auxes must match the column order in RHAON II and both must match the vertical order of the modules.
Refer to the section on Column Order in the RHAON II User Manual.
If power was connected to the Array before setting the DIP switches, it will need to be disconnected and reconnected before the DIP switch
settings will take effect.
AUX #2
1 2
O
N
AUX #3
1 2
O
N
AUX #4
1 2
O
N
Aux
Setup DIP
Switches
and Legend
