Users Manual
12
FERRITE CLAMP INSTALLATION
The included ferrite clamps are required to be installed, as shown below, to reduce radio frequency interference.
1. Form a loop in each analog audio cable and the power cable (Pic 1).
2. Using a small clamp for audio cables and a large clamp for the power cable, insert two runs of the loop into the
clamp. The clamp on the audio cable should be approximately 3 inches (80mm) from the connector (Pic 2).
3. Press the clamp to close it and engage the plastic locks (Pic 2).
4. With all the ferrite clamps installed and the cables connected, the original rear panel service cover must be
installed with all the originally included screws.
Pic 1
Pic 1
Pic 2
Pic 2
Pic 2
