4 7
2
0 5
1 2 3 4
or
1
1 0
4 3 2 1
#
Enter the memory code "47".
Program a guest ID (in this example, the guest ID is "2").
Enter the guest code settings. In this first example for guest ID 2, the code
"1234" can be used for 5 hours.
Guest ID 1 allows the code "4321" to be used for 10 hours. The guest code
in the second example is "4321".
After the preset time limit has elapsed, the guest code becomes invalid and
will not be recognized by the code lock.
Press the # key to confirm your entry and save the guest code. The code
lock will beep twice to confirm that the guest code has been saved.
If the entry was incorrect or unsuccessful (e.g. you entered a 3-digit guest
ID), the code lock will beep and the yellow LED will flash five times.
Repeat the above steps to configure additional guest codes up to guest ID 9. Entering a new
code to an assigned guest ID will overwrite the previous guest code. It is not necessary to
manually delete the guest code.
*
Press the * key to exit programming mode. The yellow LED will start to
flash again.
h) Deleting guest codes
To delete a guest code that is no longer required, proceed as follows:
47 + [Guest ID] # = Deletes the guest code
3 2 8 9
*
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
4 7
2
#
Enter the memory code "47".
Enter the guest code ID of the guest code that you want to delete.
Press the # key to confirm your entry.
The corresponding guest code will be deleted.
*
Press the * key to exit programming mode. The yellow LED will start to
flash again.
62
