1
0 1
8 3 2 2 1
#
or
1
0 2
8 3 2 2 2
#
Enter the memory code "1".
Program a user ID (in this example, the user ID is "01").
Enter the user code (in the first and second examples, the user codes are
"83221" and "83222").
Press the # key to confirm your entry. The code lock will beep twice to
confirm that the user code has been set.
If the entry was incorrect or unsuccessful (e.g. you entered a 3-digit user
ID), the code lock will beep and the yellow LED will flash five times.
Repeat the above steps to configure additional user codes up to user ID 99.
Entering a new code to an assigned user ID will overwrite the previous user
code. It is not necessary to manually delete the user code.
*
Press the * key to exit programming mode. The yellow LED will start to
flash again.
The code lock is now in manual confirmation mode.
f) Deleting user codes
If multi-user mode is enabled and you wish to disable access for one of your employees, you
can delete one or more user codes.
1 + [user ID 0 to 99] + #
3 2 8 9
*
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
1
0 8
#
Enter the memory code "1" and the user ID (e.g. "08").
Press the # key to confirm your entry.
The user code for user ID "08" will be deleted.
*
Press the * key to exit programming mode. The yellow LED will start to
flash again.
g) Setting the guest code
Guest codes can be used to give guests or workmen temporary access to access-restricted
areas. Guest codes can be configured for single use or can be programmed to remain valid for
a specified period.
60
