Renishaw RMI-QE, Installation Manual

Page: 14 / 54

RMI-QE installation guide
2.4
RMI-QE basics
P1, P2, P3, P4 SYSTEM STATUS LEDs
LOW BATTERY
PROBE STATUS LED
ERROR LED
SIGNAL LED
ERROR DISPLAY
The following LED combination means there is a system error:
P1, P2, P3 and P4 system status LEDs - 1, 2 or 3 LEDs may be continuous red.
If powering the RMI-QE off and back on does not clear the error, contact Renishaw.
Off – Probe number empty.
Orange – Probe number full, in standby.
Green – Probe number full, operating.
Red – System error.
Orange/off – Flashing: Selection error.
Green/orange – Flashing: Partnering/clearing pending, probe full.
Green/off – Flashing: Partnering pending, probe empty.
Red/orange – Flashing: Partnering complete, probe full.
Red/off – Flashing: Clearing complete, probe empty.
Green/red – Flashing: Probe authentication error.
Off – Battery is OK and no M-code start/stop in progress.
Red – Battery is low.
Green – M-code start/stop in progress.
Orange – Battery low and M-code start/stop in progress.
Red/off – Flashing: RMI-QE has an overcurrent condition.
Red – Probe triggered.
Green – Probe seated.
Red/off – Flashing: RMI-QE has an overcurrent condition
.
Off – No error.
Red – Error, other outputs may be incorrect.
Red/off – Flashing: RMI-QE has an overcurrent condition
Off – No probes operating.
Green – Good communications.
Green/orange – Good communications.
Red – Poor communications, radio link may fail.
Red/off – Flashing: RMI-QE has an overcurrent condition.
Probe status – Red/off flashing.
Error – Red/off flashing.
Low battery – Not lit.
Signal – Not lit.