Renesas R0E521000EPB00, User Manual

Page: 59 / 88

R0E521000EPB00 User’s Manual 3. Usage (Emulator Debugger)
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 59 of 88
(4) Setting the combinatorial event condition for the hardware breakpoint
1) Window for setting the combinatorial event condition
Setting the combinatorial event condition
There are following four conditions that you can choose for the
combinatorial events.
- AND
The program breaks when all of the specified events occur.
- AND (Same Time)
The program breaks when the specified events occur at the
same time.
- OR
The program breaks when one of the specified events occurs.
- STATE TRANSITION
The program breaks when the state transition diagram goes into
the break state.
For each event, a pass count (number of passing) is specifiable (1--
255). When “AND” (same time) is specified for Combination, you
can not specify the pass count (fixed to one).
When you have finished setting the combinatorial event condition,
click the “Set” button.
Enable H/W Break
H/W Break Point Setting Window *
Combination
PID
Reset Save... Load... Set
Close
Enable Detail... Detail...