R0E521000EPB00 User’s Manual
1. Outline
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 18 of 88
1.4 Specifications
Tables 1.5 and Table 1.6 list the specifications of the R0E521000EPB00.
Table 1.5 R0E521000EPB00 specifications (1)
Applicable MCUs
R8C/Tiny Series MCUs
Maximum ROM/RAM capacity
ROM capacity: 112KB (04000h to 1FFFFh) + 4KB (02000h to 02FFFh)
RAM capacity: 8KB (00300h to 012FFh, 03000h to 03FFFh)
Usable mode
Single-chip mode
Maximum operating frequency
20MHz at 3.0--5.5V
10MHz at 2.7--5.5V
5MHz at 2.2--5.5V
User system connected 2.2--5.5V
*1
(depends on the Power selection jumper)
Applicable power supply
User system not connected
5.0V (supplied from the emulator)
Basic debugging functions
- Download
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
Real-time trace function
- 256K-cycle bus information recordable (Bus, external trigger, time stamp)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
Real-time RAM monitor function
- 4,096 bytes (256 bytes x16)
- Data/last access result
Hardware break function
8 points (Execution address, bus detection, interrupt, external trigger signal)
Execution time measurement
function
Time between program start and stop
Maximum/minimum/average execution time and pass count of specified four zones.
Count clock: Equal to MCU Clock or 16MHz
C0 coverage
8,192KB (256KB x 32 blocks)
External trigger input/event
output
*2
External trigger input (MCU-dependent-voltage CMOS level x8) or event output (break
x1, event x7)
Host machine interface
- LPT parallel (ECP, EEP, Byte/compatibility and Nibble/compatibility modes)
- USB (USB 1.1, full-speed)
*3
- LAN (10BASE-T)
Power supply to emulator
Supplied from included AC adapter (power supply voltage: 100--240V, 50/60Hz)
*1: If using this product when the voltage is less than 2.7V, the JP1 of the R0E521000EPBM0 should be set to EXT.
For details, refer to “2.10.2 Setting the POWER Selection Jumper” (page 39).
*2: When the POWER selection jumper is switched to the EXT side, the upper limit of the external trigger input level (VI) is
3.6 [V]. Similarly, the upper limit of the event output level (Vo) is 3.3 [V].
*3: Can be connected to the USB2.0 port of the host machine.
With the USB interface of this product, not all hardware (such as host machine, USB devices, USB hub) combination will
work and guaranteed.
Summary of Contents for R0E521000EPB00
Page 2: ......
Page 88: ...R0E521000EPB00 User s Manual...
