B
A
B
Fig. 26: Wall bracket alignment RVT 265-355 DC
A: Correct alignment
B: Incorrect alignment
6
Installation
6.1 Installation of the indoor unit
The indoor unit is attached by means of a wall
bracket, taking into consideration the air outlet side
located in the lower part.
1.
Mark the mounting points on the structurally
permissible building sections according to the
dimensions of the wall bracket.
2.
If necessary, remove the break out opening
of the housing.
3.
Connect the refrigerant piping, electrical
cables and condensate drainage line to the
indoor unit as described below.
4.
Hang the indoor unit onto the wall bracket by
tilting it back slightly and by pressing the
bottom part of the unit against the bracket.
5.
Check again that the unit is level. (Fig. 27)
Fig. 27: Horizontal positioning
The wall bracket for the units must be attached
with suitable screws and anchors.
REMKO RVT series
34
