Important
To use these examples, basic installation knowledge is needed.
This explanation shows schemes for the SCB-10 with an AD249
fitted. On a SCB-02, not all zones are available.
The installation example tables are laid out as follows:
The schemes are divided in columns. All relevant connections and settings
are grouped per column.
Heat demand: The top row shows the heat demand (if applicable) for the
zone.
Hydraulic connections: Only the essential parts are shown, parts to be
connected to a PCB are numbered.
Electrical connections: The numbers in the hydraulic connections refer to
the connectors on this row. There are multiple digits to identify the type of
connection:
A
Heat demand device.
B
Bridge: These connectors must be bridged. Some bridges are
already factory-fitted, some need to be fitted for the specific
installation example.
1,2,... The numbers in the hydraulic connections refer to the connectors
on this row. Connect component no. 1 from the hydraulic scheme
to the connector shown on line 1.
Parameters to be set: The parameters are separated per PCB, and must
be set on that specific PCB.
The connectors can be found on the mentioned PCB. Take the following
into account when making the connections:
Fig.19
Zone
AD-3001510-01
Fig.20
Heat demand
AD-3001506-01
Fig.21
Hydraulic connections
AD-3001507-01
Fig.22
Electrical connections
AD-3001508-01
Fig.23
Parameters to be set
AD-3001509-01
4 Before installation
24
7734324 - v.03 - 29092020
