Doc ID: 191-7911A
Doc Rev: 080420
Pg. 33
move the bike forward in gear with the throttle closed. However,
with a small opening of the throttle the bike should move forward.
You can tune the engagement RPM of the EXP disk by changing
the spring configuration. The EXP disk comes set with the
recommended
“Medium”
setting from Rekluse. Use the following
steps to change the springs. It is
NOT necessary
to disassemble
the EXP halves to change springs!
Changing the springs
1. Using a flat-blade screwdriver, push the ¼ turn pin in far
enough to clear the opposite side of the EXP to unlock the
pin.
2. With the pin still pushed past the base, turn 90° to remove
the pin and spring.
3. Remove the remaining 2 pins and springs from the same
side of the EXP base.
4. Drop a new spring into the spring slot on the base, then add
the ¼ turn pin.
