Pg. 34
Doc ID: 191-7911A
Doc Rev: 080420
5. Push the turn pin in far enough to clear the base, then turn
90° and release the pin. The pin should sit almost flush with
the EXP base.
6. Flip the EXP friction disk over and repeat on the other side
depending on engagement preference.
7. If you need to disassemble the EXP disk, you can watch the
video on our website under Tech Tips at
www.rekluse.com/support/videos/atv-mc-support-videos.
To maintain even pressure, when using two different color spring
sets, install one set of 3 on one side of the EXP and the remaining
set of 3 on the other side.
If you disassemble the EXP, the Teflon pads may fall out or be
stuck to the ramp surfaces of the EXP bases. Take care to
ensure all pads are correctly placed into wedge pockets using
gentle pressure to avoid damage to the pad surfaces before
reassembling the EXP. Properly seated pads will be secured in
