REICH 527-0541 Installation Instructions Manual Download

Page: 41 / 68

M8 Installation of the synchronous
bars

Mount the small shrinkage tube at the end of the
synchronous bar (without drilling). It serves the
sound damping.
Shove the teles-copying synchronous bars into
each other.
The holes for the mountage must be at the out-
side. Fasten the clamp to the support of the syn-
chronous bar as much as possible in the middle
of the stabilizator bar.
Shove the synchronous bar through the clamp
and fasten the little bar by means of the enclosed
screw and nut at the spindle. Mount the second
shrinkage tube in height of the clamp on the big
bar now. Mount the big synchronous bar at the
other spindle.

M7 Fixing

Use a suitable torque wrench for fixing of all
screws and nuts.

Now fasten the bolts with 25 Nm to fix the

stabi-

lizer

and secure the bolts with the locknuts.

Make sure that the centre of the stabilizer, which
you marked, is still in the centre below the cara-
van or trailer.

Now fasten the

clamp-fastenings

of the right and

the left drive unit with 30 Nm.
Please make sure that the distance between the
drive rollers and the tyres has not changed and it
is still 15 - 20 mm.

Mount the

protection clamps or the clamp

strap

being included in the delivery scope

in front of and behind the left and right clamping-
fastenings. The clamp strap is used, if the dis-
tance plates have been installed, and it replaces a
protection clamp.
The protection clamps or the clamp strap are an
additional protection against slipping of the drive
unit at the vehicle frame.

The protection clamps and the clamp-strap are an
additional protection against the moving of the
drive units along the vehicle chassis.
Using only one bolt per protection clamp, fasten
with 30 Nm.

M5 Stabilizer bars

ATTENTION!

The length of the stabilizer bar has to be adjusted
to the vehicle in accordance with the mounting
dimensions given under

If the stabilizer bar does not enter in the square
axle of the drive unit for at least

300 mm

, you

must use a (optional available) 2 m stabilizer bar.
Otherwise the optimal function cannot be guaran-
teed.
If the enclosed stabilizer bar is too long, it must be
shortened correspondingly.

Determine the exact centre of the stabilizer and
mark it.
Push the

stabilizer bar

into the rectangular tube

of the already installed drive unit.

Lead the unassembled

drive unit over

the other

end of the stabilizer bar and fasten this drive unit
at the vehicle frame as described below M3/M4.
Screw the nuts only "hand-tight".

Now centralise the

stabilizer bar

and tighten its

binding bolts by hand.

M6 Distance drive units - tyres.

Now set the correct

distance

between the drive

units and the tyres.

ATTENTION!

For adjusting the distance the wheel must be
under full load and that the caravan must stand
on a flat underground. The distance between tyre
tread and friction rollers must be approximately
15 - 20 mm. Make sure that be the drive units are
in the disconnected position

(= OFF).

Use the little wooden block as a measure

4@.$UXJO@.#"