A5 FAQ‘s
Does the MoveControl fit any chassis ?
The MoveControl fits the majority of caravan
chassis. For special installations additional brack-
ets are available
.
The spare wheel prevents the installation of
the MoveControl.
Spare wheel carrier brackets allow us to reposi-
tion the spare wheel
.
The MoveControl gets over itself very
strongly.
Provided that the stabalizer bar not min. 300 mm
projects into the respective frame, a prolonged
stabilizer bar has to be used
.
The MoveControl cannot be switched on with
the remote control.
The isolation switch is not turned on
.
The remote control is not synchronized with both
E-boxes
.
The power supply is too low
.
The friction rollers turns at the tyre.
The distance between friction rollers and tyres is
too great. The distance must be 15 - 20 mm
.
Check tyre pressure and increase if necessary.
The MoveControl gets over itself too strongly (see
obove
).
During moving the vehicle jerks.
The supply cables or battery capacity is too small.
The minimum capacity of the battery should be
110 Ah
.
The battery of the remote control is consumed.
Replace battery or fit the connecting the cable
.
Aerial signal disrupted due to screenings or mag-
netic fields. Antenna cables can be extended to
54 cm total length and taken to the outside. Take
care that the cable does not come into contact
with metal parts
.
The red LED of the E-box shines during the
operation permanently and the MoveControl
does not react any more.
The overload protector has triggered. At strong
load the electronics switches off. Carry out reset
procedure
.
The cables to the drive motors are different
lengths, they should be the same
.
The MoveControl drives exactly opposite to
that shown on the illustrations on the remote
control.
The electronics are not attached according to the
wiring diagram
l
.
The MoveControl pulls to one side.
The cables to the drive motors are different
lengths
.
The distance between friction rollers and tyres is
not parallel
.
The tyre pressure or the weight distribution is
different
.
A4 Comments and hints
A) You can also use the MoveControl to connect
the caravan or trailer to your motor vehicle.
B) Before starting your motor vehicle, make sure
that both drive units have been disconnected
i
(= OFF).
C) Please use chocks for kerbs or other similar
obstacles.
D) Keep the remote control, the connection cable
and the manual in a dry place, inside the case
provided.
E) The MoveControl is equipped with an electrical
overload protection and automatically switches
off in case of overload. After an electric over-
load please run the reset procedure as written
in appendix A2.
F) If the remote control or one E-box has to be
replaced you have to run a synchronization
procedure as written in appendix A1.
G) If necessary, replace the batteries in your re-
mote control. To do this push off the lid on the
back of the remote control, in the direction of
the arrow. Remove the batteries and replace it
with new ones of the same type.
47
4@.$UXJO@.#"
4@.$UXJO@.#"
Summary of Contents for 527-0541
