9
C.1.1
C.1.2
Warning
C.1 Wall
installation
Install the controller in dry areas only.
Installation instructions::
1. Unscrew cover screw completely.
2. Carefully pull the upper part of the hou-
sing from the lower part.
3. Set the upper part of the housing aside,
being sure not to touch the electronics
when doing so.
4. Hold the lower part of the housing up
to the selected position and mark the 3
mounting holes. Make sure that the wall
surface is as even as possible so that the
housing does not become distorted when
it is screwed on.
5. Mark the position on the wall with a
pencil. Using a drill and size 6 bit, drill 3
holes at the points marked on the wall and
push in the plugs.
Fig. C.1.2.
6. Insert the upper screw and screw it in
slightly.
7. Fit the upper part of the housing and
insert the other two screws.
8. Align the housing and tighten the three
screws.
Installation
