15
E.2 Commissioning
help
E.3 Free
commissioning
If you decide not to use the commissioning help, you should make the necessary
settings in the following sequence:
- Menu 9.
Language (page 35)
- Menu 6.12
Time and date (page 32)
- Menu 6.1
Program selection (page 27)
- Menu 4.
Settings, all values (page 20)
- Menu 5.
Protective functions if modifications are necessary (page 24)
- Menu 6.
Special functions if additional changes are necessary (page 27)
Finally, menu 3.2 under operating mode “Manual“ should be used to test the switch
outputs with the consumers connected, and to check the sensor values for plausibility.
Then switch on automatic mode.
ons of each parameter in the display.
Pressing the “esc” key takes you back to the previous value so you can look at the
selected setting again or adjust it if desired. Pressing the “esc“ more than once takes
you back step by step to the selection mode, thus cancelling the setup wizard. Finally,
menu 3.2 under operating mode “Manual” should be used to test the switch outputs
with the consumers connected, and to check the sensor values for plausibility. Then
switch on automatic mode.
The
fi
rst time the controller is turned on,
language and clock need to be set.
After that a query appears as to whether
you want to parameterize the controller
using the Setup Wizard or not. The setup
wizard can also be terminated or called up
again at any time in the special functions
menu. The setup wizard guides you throu-
gh the necessary basic settings in the
correct order, and provides brief descripti-
Operation
Caution
Observe the explanations for the individual parameters on the following
pages, and check whether further settings are necessary for your
application.
