21
│
Sentinel Kinetic Advance S, SX - www.regulus.eu
Powering up the Unit
Switching On
To switch the unit on:
1.
Switch on the power at the mains supply isolator feeding the unit.
2.
Following switch-on, the fan motors will start and the Control Unit will display a start-up screen,
described on page 22.
N.B. If you are intending to carry out work or maintenance inside the unit, isolate the supply to the
unit before removing any covers.
Switching Off
To switch the unit off:
1.
Turn the power off at the mains supply isolator.
Overview
The instructions in this section are intended to provide configuration and operation information for setting
up the equipment. In the event of problems, see Diagnosing a Problem on page 48.
Follow good practice when commissioning the unit. Ensure that the system is installed according to the
system designers intent incorporating any acoustic ducting, that all joints are air tight, ducting is well
supported, bends are avoided close to vents, and that the vent valves are fully open at the start of the
commissioning process.
Control Unit Touch Screen Display
The Control Unit is located at the front of the Sentinel Kinetic Advance unit. The Control Unit provides the
user interface for commissioning and monitoring purposes. The display is a resistive touchscreen with LED
backlight, which will turn off to automatically after 5 minutes to minimise power consumption. To activate
the backlight, touch the display.
Navigate through the functions by pressing the
symbols, adjust settings using the
-
buttons. A
symbol indicates that there are further screens related to a menu option. Select the
option on the touchscreen to access the related screens.
User mode (Boost)
button
Status bar
Settings & Performance bar
Scroll Left
Scroll Right
