16
|
Regency Plateau® PTO30-1 Outdoor Gas Fireplace
|
16
installation
PTO60 WALL SWITCH AND BATTERY INSTALLATION
(INCLUDED WITH UNIT)
919-070
08/15/11
2
PTO30 / PTO60
PTO60 WALL SWITCH INSTALLATION
(INCLUDED WITH UNIT)
Note: Each PTO30 comes with a wall switch. However, only
one
wall switch
is required. The 2nd switch can either be discarded or saved as a spare
part.
The units come with a low voltage wire and a battery extension wire in-
stalled on each burner.
1)
Run supplied wire to desired location - to a max. of 9 feet for both
burners.
2)
Install supplied electrical box in desired location.
3)
Remove center knock out from electrical box and install strain relief
(strain relief nut not required).
4)
Connect both sets of low voltage wires together from each burner - white
with white and black with black.
5)
Route low voltage wires and battery extension wire through the strain
relief.
Note:
Ensure the battery extension wires are approx. 8" in length inside the
electrical box.
This excess will ensure ease of battery replacement and servicing in
the future.
8)
Using silicone, completely seal strain relief to protect from water or moisture.
9)
Place supplied gasket on top of electrical box.
10)
Fasten cover to electrical box using supplied screws.
11)
Place switch in OFF position until fi nal installation is complete.
Center knock out
Slide 1st battery
pack to the right.
Strain Relief
6)
Attach low voltage wires to the switch - ensure to attach on the right side
of the switch. This will make it easier to remove the 2nd battery terminal
when replacing batteries. Fasten switch to right side of electrical box as
shown below.
7)
Install 4- AA batteries into each battery terminal. Ensure correct polarity.
Slide the fi rst battery terminal all the way to the right - until it is next to the
switch.
The 2nd battery terminal can be attached to the battery cover with the
supplied velcro.
NOTE:
PTO60 is two PTO30 units assembled end to end.
