28
|
Regency Plateau® PTO30-1 Outdoor Gas Fireplace
|
28
installation
ASSEMBLY INSTRUCTIONS FOR A STEEL STUD
TABLE FRAMING KIT FOR PTO60
919-144
03/17/14
1
OUTDOOR BURNER
Vent Location
Vent Location
Vent Location
Vent Location
ASSEMBLY INSTRUCTIONS FOR A STEEL STUD
TABLE FRAMING KIT FOR THE 60" BURNER
Follow these instructions to construct a steel stud table for the 60" burner;
Overall dimensions = 24" W x 24" H x 79" L.
NOTE:
60`Unit is two 30" Units assembled end to end.
**Non-combustible fi nishing board not supplied with kit. Board may be purchased at your local hardware/building supply store.
Tools Required
1 power
drill
+ #2 phillips bit
1 hand
#2 screwdriver
(Phillips)
1 level
1
tape
measure
377-910 CONTENTS:
Top / Bottom
(A) x 2
Vertical Supports - Corner
(B) x 4
Vertical Supports - Inner
(C) x 6
Vertical Supports - Outer
(C) x 4
Wafer Screws
80
Vent (377-060)
2 x Upper
Vent (377-061)
2 x Lower
Note:
60`burner - Four (4) ventilation grills are required for all enclosures.
This is to alleviate moisture and allow for air to circulate. Minimum recommended size 20"sq (508mm²) ea.
* Alternative to installing grills would be to raise the 60`burner frame a minimum of 1" (25mm) to allow air circulation from underneath.
Important Note: Four (4) ventilation grills are highly recommended for all the PTO60 steel stud framing kit.
This is to alleviate moisture and allow for air to circulate underneath this burner. Minimum recommended size: 20" sq (508 mm²) ea.
