37
a) Mounting the Elevators and Rudders
Place the rudder (1) in the intended cut-out in the elevator (2) and this unit into the cut-outs at the fuselage. Imprecise
fits should be carefully corrected with a cutter knife and/or fine sand paper.
Also check if installation at an angle of 90° is possible without problems.
When everything is perfect, attach the elevator with the rudder to the fuselage with two M3 x 40 mm screws (3).
Check if installation according to figure 2 is possible without problems. Ideally, the wing should be installed for this and
the tail unit aligned according to figure 1.
Figure 1
Figure 2
